- Solar Products
- -Solar Module
- -Solar Lamp
- -Solar Fan Caps
- -Solar Products For Family
- -Solar Rechargeable Fans
- -Solar Supporting Products
- -Solar Products For Industry
- -Solar Bag
- Proximity Switch And Sensor
- -Inductance Type Proximity Angular column type
- -Inductance Type Proximity Cylindrical Type
- -IC Capacitive Proximity Switches
- -Capacitance Proximity Switch
- -Photoelectric Switch
- Low Voltage Electrical Products
- -AC Contactor
- -Mini Ciruit Breaker
- -Relay
- -Surge Protective Device
- -Residual Current Device
- -Fuse
- -Moulded Case Circuit Breaker
- Meter Series
- -Electronic Meter
- -Mechanical Meter
- -Temperature Controller
- Switch And Socket
- -Floor Socket
- -Universal Adapter
- -Wall Switches
- Plastic Products
- -Cable Connector
- -Cable Clamps Tie Mounts
- -Terminal Block
- -Heat-Shrinkable Tubings
- -Cable Clip
- -Nylon Cable Ties
- Pushbuttons
- Indicator Light
- Isolating Switch
- Toggle Switch
Feature
YD8000 series panel meters adopt modular design. Customers may order models in various dimensions according to the application. The meters with PIC chip have strong resistance to interferences, and the performance/cost ratio is high.
Installation,Material & Isolation
Installation modeMounting installation,wring at the back
Material of outer caseNon-flammable
Isolation Between power supply/input/output
Performance
Measurement: Single Phase Power Factor
Measuring range: 0-360°
Accuracy: ≤±0.02 PF
Input Range: Voltage: AC 90-380V
Current: AC 0-5A
Display range: - 1- 0- 1
Measuring speed: About 1.5 times/s
Frequency: 40-60Hz
Polarity indication: Capacitive loading
Power supply: AC220V±20,50/60Hz
Power consumption: ≤2VA
Working frequency withstands voltage: Between power supply/input/output: ≥AC2kV/min·1mA
Insulation resistance: ≥100MΩ

Operating Notice
n The operating environment allows no electric dust or gases that corrodes metal or destroys insulation.
n Operating conditions: temp.: -10-50, RH 10-95The altitude is less than 2500m.
n User shall connect the measured signal source and auxiliary power supply correctly according to the plate on the outer case of the meter.
n No extra setting is needed. Only connect the meter to the measured signal source and the auxiliary power supply.
|
|



